View source for Did

The /did command allows you to modify the values of controls in a dialog, eg. changing the text in an edit control, or setting focus to a button, or deleting lines in a listbox.

  '''/did -ftebvhnmcukradiogjsl name id [n] [text | filename]'''
  Where name identifies the dialog and id is the id number of the control you want to modify.

  -f	set focus on id
  -t	set id as default button
  -e	enable id
  -b	disable id
  -v	make id visible
  -h	hide id
  -n	enables editbox
  -m	disables editbox
  -c	check checkbox/radiobutton list/combo line
  -u	uncheck checkbox/radiobutton list/combo line
  -k	works with -cu, keeps other selections in a listbox
  -s	checks the checkbox of an item in a listcb control
  -l	unchecks the checkbox of an item in a listcb control
  -r	clear all text in id
  -a	add line of text to end
  -d	delete Nth line
  -i	insert text at Nth line
  -o	overwrite Nth line with text
  -g	set a new icon/bmp to an icon control /did -g name id [n] filename
  -z	resets the width of horizontal scrollbar in listbox
  -j	resets the edited setting in an editbox



If you want to modify several controls at the same time, you can specify multiple id numbers separated by commas, eg. /did -b name 2,12-16,20 etc.

You can select a range of text in an editbox using /did -c name id [n] [start [end]]. This selects line N in editbox, and sets selection to specified range of characters.

You can mark a 3state checkbox as indeterminate by specifying both -cu switches.

You can access the edit control in a combobox by using 0 as the N value.

To change the range of a scrollbar control, you can use /did -z name id [min max].


[[Category:Dialogs|Did]]
[[Category:Commands|Did]]