Difference between revisions of "On usermode"
From Scriptwiki
m |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 30: | Line 30: | ||
if (%m == +) { echo -a Mode +x was just set. } | if (%m == +) { echo -a Mode +x was just set. } | ||
} | } | ||
| + | [[inc]] %i | ||
} | } | ||
== See Also == | == See Also == | ||
| − | + | * [[On_mode|On Mode event]] to react on channelmode changes. | |
[[Category:Events]] | [[Category:Events]] | ||
Latest revision as of 10:00, 2 July 2007
The on USERMODE event triggers triggers when you change your usermode.
on <level>:USERMODE:<commands>
Read access levels to get more info about the <level> field.
Note that $1- refers to the changed usermode.
Example
on *:USERMODE: {
echo -a Changed usermode: $1-
}
This event would trigger when you get the confirmation of a usermode changing and echo's it to the active window.
To check if you e.g. have set +x is more complicated as $1- could e.g. be "-w+x", so you have to loop through $1-.
on *:USERMODE: {
; set looping variable and %m as variable holding whether the current mode we are looking at
; was set or unset
var %i = 1, %m
; begin to loop through $1-
while (%i <= $len($1-)) {
; check if the current char is "-" and set %m to it (all modes will be unset after "-")
if ($mid($1-,%i,1) == -) { %m = - }
; check if the current char is "+" and set %m to it (all modes will be set after "+")
if ($mid($1-,%i,1) == +) { %m = + }
; if the char we are looking at is "x"
if ($mid($1-,%i,1) == x) {
; we need to check whether %m is "+" (so x is set, not unset) and echo it
if (%m == +) { echo -a Mode +x was just set. }
}
inc %i
}
See Also
- On Mode event to react on channelmode changes.
