Bcopy

The bcopy command is used to copy a (part of a) binary file.

bcopy [-zc] <&copy> <N> <&source> <S> <M>

This copies M bytes from &source starting at position S to &copy starting at position N. If &copy doesn't exist yet, the binary file will be created and zero filled to the Nth byte. If &copy already exists but smaller then N bytes, it will be extended with zeros to the Nth byte. If &copy already exists and is N bytes or larger, the copied bytes will overwrite the old bytes in &copy. If &source is smaller then S + M - 1 bytes and &source is equal or larger then S bytes, then all bytes starting from S to the last byte will be copied. If &source is smaller then S bytes, you will get an error. You can use M = -1 to copy all bytes starting from byte S to the last byte.

The -z switch will zero fill all bytes in &source that were copied. The -c switch will chop &copy to N + M bytes.

Examples

bset &data 65 66 67 68 69
bcopy &test 1 &data 3 2
echo -a $bvar(&test,1,$bvar(&test,0))

This will copy the values 67 68 from &data to &test.